Description

!!!THIS IS NOT A FULL SLIDER!!!

Included in your order will be 1 Set of 3D Printed Tops, 1 Set of Ti Collars, and 1 Set of SS Screws.

Looking for a lighter, more budget friendly top that provides less worries about drops, spills, and falls? Then 3D ErgoBoy Tops may be the perfect setup for you! Printed with 100% infill these tops are made to last and have a little weight to them, albeit still very light. 

Weight when fully put together with plates and acrylic inserts is approximately: 40.74g

PLEASE DO NOT MESSAGE ME ASKING ABOUT PLATES, INSERTS, OR MAGNETS!!!!




----------------------




DISCLAIMERS



3D Printed pieces can have minor imperfections, little rough spots, or little pits, this is normal. We strive to make all of our products as "flawless" as possible, but minor inconsistencies can still be there. 3D pieces could warp, the area where the bodies meet may not be flush or always remain flush. Please DO NOT over tighten the screw, they just need to be snug not tightened using all of your force. Once ANY package is marked as DELIVERED the transaction is complete and I WILL NOT REFUND OR REPLACE STOLEN GOODS. You are not guaranteed to received stickers or magnets in your order, and I will not send additional ones if you did not receive any. By purchasing this piece you AGREE to all terms described above.